Starting Up E5091A; Turning On/Off The Power; Cutting Supply Of Power - Agilent Technologies E5091A User Manual

Starting up E5091A

This section describes how to turn ON/OFF the E5091A and how to cut the supply of
power in an emergency.

Turning ON/OFF the power

Turning ON power
Step 1. Check that the line switch in the lower left part of the front panel is pulled up (
is pushed in (
(
Step 2. Push the line switch to push it in (
Turning OFF power
To turn OFF the E5091A, do the following.
• Push the line switch in the lower left part of the front panel so that the switch pushed in
(
NOTE
To turn OFF the E5091A in normal times, press the line switch. In normal times, never
disconnect the power cable to cut the supply of power to the power cable receptacle
on the rear panel.

Cutting supply of power

For the E5091A, the disconnecting device (the device to cut the supply of power) is the
plug of the power cable (on the power outlet side or the E5091A side).
If you need to cut the supply of power to avoid danger of electric shocks, disconnect the
plug of the power cable (on the power outlet side or the E5091A side).
NOTE
Follow the description in "Providing space to disconnect the plug of the power cable" on
page 16 so that you can perform this operation reliably.
To turn OFF the power in normal times, be sure to follow the procedure in "Turning OFF
power".
1
) which means the power is OFF, push the standby switch to pull it up
).
) is pulled up ( ).
Starting up E5091A
).
Installation
). If it
23