I2S Serial Decode - Agilent Technologies InfiniiVision 3000 User Manual

To display I2S serial decode, see
N O T E

I2S Serial Decode

To set up the oscilloscope to capture I2S signals, see
Signals"
For I2S triggering setup see
N O T E
To set up I2S serial decode:
1 Press [Serial] to display the Serial Decode Menu.
2 Press the Base softkey to select the number base in which to display
3 If the decode line does not appear on the display, press the [Serial] key
4 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and
If the setup does not produce a stable trigger, the I2S signal may be slow enough that the
N O T E
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
You can use the horizontal Zoom window for easier navigation of the
acquired data.
See Also
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on page 381.
decoded data.
to turn it on.
decode data.
"Interpreting I2S Decode"
"Interpreting I2S Lister Data"
"I2S Serial Decode"
"I2S Triggering" on page 384.
on page 388
on page 389
I2S Triggering and Serial Decode
on page 387.
"Setup for I2S
25
387