Table of Contents
Advertisement
Avaya G860 Media Gateway
To insert an SC board into the chassis, take these 6 steps:
1.
Hold the board Horizontal with the top of the board pointed upward.
2.
With the black ejector/injector latches in the open (pulled out) position, insert the
board in the slot, aligning the board on the grooves on each end.
3.
Ease the board all the way into the slot until the ejector/injector latches touch the
chassis. The blue hot-swap LED is lit.
Note:
Push in the board until it is flush with the other boards. The SC board
requires extra pressure to ensure it is pushed in back sufficiently.
4.
Press the two black ejector/injector latches on both ends inward, toward the
middle until you hear a click.
5.
Wait for the hot-swap blue LED to turn off.
6.
Fasten the screws on the front plate of the board to secure the board to the
chassis and to ensure that the board has an earth connection to the chassis.
14.2.1
Installing the Solaris™ 9 OS
The Solaris™ operating system is installed on the SC board. Each version of Avaya
G860 Media Gateway software requires a specific version of Solaris™ OS, which is
configured specifically for full Avaya G860 Media Gateway hardware compatibility and
high performance.
When it becomes necessary to re-install the Solaris™ OS on an SC boards, it is
important to use the Solaris OS installation image provided by Avaya.
Avaya G860 Media Gateway version 3.2 software requires Solaris™ 9 9/04.
14.2.1.1
Installation Requirements
Installation of Solaris™ OS on SC boards is performed via the network. The Solaris™
OS Installation image must be placed on an Install Server that fulfills the following
requirements:
Solaris™ 8 2/02 or later
CD-ROM Drive
At least 2 Gb free disk space in the root file system
Resides on the same subnet with Avaya G860 Media Gateway
Avaya recommends using the EMS server as the Install Server.
Note:
The Install Server must reside on the same LAN with Avaya G860 Media
Gateway (i.e., it must be connected to the same Ethernet Switch.
The installation is to be performed on the SC board while it resides in the Avaya G860
Media Gateway chassis. In addition, the SA/RTM must also be in place behind the SC
board during the installation process.
132 Installation & Operation Manual
Advertisement
Table of Contents
Troubleshooting
