Disable Secure Mode; Software Re-Installation; Disable Secure Mode Examples - Avaya G860 Installing And Operating

Avaya G860 Media Gateway
12.8.3.4

Disable Secure Mode

To disable Secure Mode, take these 5 steps:
1. Connect to both SC boards via Secure Shell (SSH)
2. Stop software on both SC boards – "tools tg dn"
3. On the Primary SC board:
•
Run installation script "/install.pl"
•
Choose option "3 – Change installed configuration"
•
Select "Enable Security – no"
4. On the Secondary SC board
•
Run installation script "/install.pl"
•
Choose option "4 – Copy configuration from Primary SC "
•
Provide root password on Primary SC (the one you changed earlier)
•
Rest of the configuration, including security settings, will be copied from the
Primary SC
5. Reboot both SC boards
12.8.3.5

Software Re-Installation

Secure Mode may be disabled during software re-installation (option 2 in /install.pl
script). The procedure is similar to the one described above.
12.8.3.6

Disable Secure Mode Examples

The following is an example of a System Configuration with a disabled Security mode.
System configuration
------------------------------------------------
Keyboard shortcuts:
ENTER
\
Ctrl-C - abort configuration script
Global SC IP Address
Master SC IP Address
Redundant SC IP Address (or 1.1.1.1 if none) [10.7.13.94]:
EMS Server IP Address
NTP Server IP Address
Enable Security (0-no, 1-yes)
SC Root Password
SNMP Read Community
SNMP Write Community
114 Installation & Operation Manual
- leave default parameter value
- return to previous parameter
[10.7.9.242]:
[10.7.13.45]:
[10.7.6.8]:
[0.0.0.0]:
[0]: 0
[leave unchanged]: ******
[leave unchanged]: ******
[leave unchanged]: ******