Testing The Installed System - Avaya G860 Installing And Operating

13

Testing the Installed System

After the hardware installation process is complete, software is configured, and the
EMS has been configured, perform a test to verify that each board is operating.
To ping the SC boards from the PC, take these 3 steps:
1. From the Start menu, select RUN and at the command prompt, enter cmd.
2. At the command prompt, enter ping [Global IP address of an SC board]. A
response should be received.
Note:
3. Using Telnet, access each SC board and run the command: tools tg p
A list of SC software processes appears. Refer to the example below.
SC-1::~# tools tg p
LIST OF SC SOFTWARE PROCESSES:
-------------------------------
6559 tg_megac tg_megaco
6558 tg_core
6557 tg_bootp tg_bootp
6556 tg_tpncp tg_tpncpif
6555 tg_sat
6554 tg_mgcp
6553 tg_hbg
6552 tg_hbm
6531 tg_watch /Project/bin/exe/tg_watchdog
The following is an example of the list of SC software processes that appears if
there is a problem in the SC software installation. If this occurs, the installation
must be redone.
SC-1::~# tools tg p
LIST OF SC SOFTWARE PROCESSES:
-------------------------------
6531 tg_watch /Project/bin/exe/tg_watchdog
4. In the EMS application, open the Media Gateway Status screen and check the
status of the system elements. For more information, refer to the Element
Management System User's Manual, Document #: LTRT-910xx.
If the Ping has not received the proper response, check the physical
connections to the network.
tg_core
tg_sat
tg_mgcp
tg_hbg
tg_hbm
13. Testing the Installed System
Issue 1 October 2007 127