Removing An Media Gateway Board - Avaya G860 Installing And Operating

19.1.4

Removing an Media Gateway board

When a Media Gateway board is removed from the system, you must remove its MIB
parameters.
To remove the MIB parameters of a removed Media Gateway
board, take these 3 steps with the MIB elements located under the
following path:
..\tgConfig\tgModule\tgSlotTable\tgSlotEntry
1. Remove a configured board from a chassis slot by setting tgSlotActionType =
removeBoard. As a result:
When working with a MIB browser, a table of the slots is displayed.
Select the appropriate specific slot number.
2. Verify the performed operation by reading tgSlotBoardType to compare with the
configured VoP board type at the selected slot number.
3. Check that the board has been deleted by examining the
moOperativeStateChange alarm, which indicates that AlarmSource = selected
board# and ProbableCause = disabled.
(Refer to 'List of Alarms' on page 181, or the Programmer's User Manual,
Document#: LTRT-914xx, for the Alarm values.)
19. Appendix - Getting Started with MIBs
Issue 1 October 2007 205