Table of Contents
Advertisement
To restore the SC software from the backup file, take these 11
steps:
1.
Shutdown both SC boards either using the EMS (refer to EMS documentation) or
by typing the command tools tg dn at the Telnet prompt on both SC boards. You
are prompted to confirm this command.
2.
Connect to the Active SC board using Telnet. (Refer to 'Console Terminal
Cabling' on page 73.)
3.
Use ftp to copy the tar file from its safekeeping location outside of the SC board
to the SC board.
4.
At the prompt, type tools tg rs and press Enter. The Restore procedure is
activated.
5.
You are prompted to choose from the two types of backups. To restore the full
backup, type 2 and press Enter.
----------------
SC software supports 2 backup types:
1) Database Backup
Backs up only configuration database.
Works fast and produces small backup files, however it
cannot be restored if software installation is broken
or destroyed.
2) Full Backup
Backs up complete software installation, including
configuration database.
Works slow and produces large backup files, however it
is able to restore all software components.
What backup will you restore (1-Database/2-Full) ? 2
6.
The Full Restore procedure is activated. Just in case, you are reminded that this
procedure must be run only when the SC application is down on both of the SC
boards and you are prompted to confirm the action. Type y and press Enter.
Full Restore
------------
This tool will restore from backup complete software installation
including configuration database.
IMPORTANT: You must run this tool only when SC application is
down on both SCs.
Restore (y/[n]) ? y
10. SC Software Backup/Restore Procedures
Issue 1 October 2007 93
Advertisement
Table of Contents
Troubleshooting
