Installing The Sc Software; Sc Installation Package; Copying The Sc Software - Avaya G860 Installing And Operating

14.2.2

Installing the SC Software

To install the SC software, take this step:
Following the directions in 'Configuring System Controller Software for the First Time'
on page 73, connect the console terminal to the SC board.
14.2.3

SC Installation Package

The SC installation package is provided on Avaya G860 Media Gateway System
Software Installation CD included in the accessory kit accompanying the Avaya G860
Media Gateway. The following is the software component on the CD:
Directory File
Mediant_SC_SW sc_software.tar.gz
14.2.4

Copying the SC Software

To copy the SC software, take these 4 steps:
Via the IP network, connect to the SC board from the PC terminal using Telnet.
Note 1:
Note 2:
1. Copy the installation package from the SC software CD to the SC board using the
example below. This can be performed using FTP.
Note:
Example for copying the file:
Entered text is shown in bold and the IP address of the SC board is assumed to be
10.1.2.3.
Table 38: SC Installation Package Files
Ensure that the PC terminal you are using is connected to the same IP
network to which the Avaya G860 Media Gateway is also connected.
If for any reason you cannot establish a connection via the IP network, you
can alternatively connect via one of the RJ-45 ports in the Ethernet Switch
RTM provided in the optional integration kit.
The installation package files of more than one product may be provided on
the CD you receive. Be sure to select the directory and installation package
files appropriate for your system.
14. Hardware Replacement Procedures
Description
The tar file containing compressed SC software
and related files
Issue 1 October 2007 135