Configuring The Ip Address Of The Es Board Software; Power Supply Module Replacement - Avaya G860 Installing And Operating

Avaya G860 Media Gateway
9. In the EMS Main screen, Status pane, double click on the Ethernet Switch board
of the RTM that has been replaced. In the dialog box that appears, verify that the
uplink port is enabled.
14.6.1

Configuring the IP Address of the ES Board Software

If the ES board fails to unlock in the EMS and remains with a Red indicator, the ES
board requires that its IP address is reconfigured.
configure the correct IP address for the ES board.
To configure the IP address on the ES board, take these 4 steps:
1. Connect to the Switch Board's RS232 console.
2. Log in using the username: admin and password: password.
Escape character is '^]'.
PTI CPC4411 (from application)...
login: admin
Password: password
#
3. Configure the IP address on Ethernet Switch board (note that this configuration
does not survive reset, hence you should immediately proceed to the software
installation as described above).
# ip config sw0 10.1.1.35
4. Repeat the lock/ unlock procedure on the ES in the EMS.
14.7

Power Supply Module Replacement

To remove a faulty power supply, take these 4 steps:
1. Unfasten the 4 screws on the plate of the power supply to be removed.
2. Press the red ejector button on the black ejector/injector latch.
3. Pull on the ejector/injector latch and ease out the power supply from the slot.
4. In the EMS, verify that the alarm (regarding the faulty power supply) is now clear.
To insert a replacement power supply, take these 6 steps:
1. Hold the power supply horizontally with the black ejector/injector latch pointed
outward.
2. With the black ejector/injector latch in the open (pulled out) position, insert the
power supply in the slot.
3. Ease the power supply all the way into the slot until the ejector/injector latch
touches the chassis.
154 Installation & Operation Manual
Use the procedure below to