Avaya G860 Installing And Operating page 153

To insert an Ethernet Switch board into the chassis, take these 9
steps:
1. Hold the board Horizontal with the top of the board pointed upward.
2. With the black ejector/injector latches in the open (pulled out) position, insert the
board in the slot, aligning the board on the grooves on each side.
3. Ease the board all the way into the slot until the ejector/injector latches touch the
chassis. The blue hot-swap LED is lit.
4. Press the two black ejector/injector latches on both ends inward, toward the
middle until you hear a click.
5. Wait for the hot-swap blue LED to turn off.
6. Fasten the screws on the front plate of the board to secure the board to the
chassis and to ensure that the board has an earth connection to the chassis.
7. Reconnect the cables.
8. In the EMS, unlock the Ethernet Switch board that has been replaced. For more
information refer to the Element Management System User's Manual, Document
#: LTRT-910xx.
9. After 5 min., in the EMS, verify that the Ethernet Switch board is enabled.
To remove an Ethernet Switch RTM from the chassis, take these 4
steps:
1. In the EMS, lock the Ethernet Switch board of the RTM to be replaced. For more
information refer to the Element Management System User's Manual, Document
#: LTRT-910xx.
2. Remove the connected cables.
3. Unfasten the screws on the plate of the board.
4. Pull on the two ejector/injector latches and ease out the board from the slot.
To insert an Ethernet Switch RTM into the chassis, take these 9
steps:
1. Hold the board Horizontal with the top of the board pointed upward.
2. With the black ejector/injector latches in the open (pulled out) position, insert the
board in the slot, aligning the board on the grooves on each end.
3. Ease the board all the way into the slot until the ejector/injector latches touch the
chassis.
4. Press the two black ejector/injector latches on both ends inward, toward the
middle until you hear a click.
5. Fasten the screws on the front plate of the board to secure the board to the
chassis and to ensure that the board has an earth connection to the chassis.
6. Reconnect the cables according to the IP Separation configuration. (Refer to'
Ethernet Switch Boards' on page 34.).
7. In the EMS, unlock the Ethernet Switch board of which the RTM has been
replaced. For more information refer to the Element Management System User's
Manual, Document #: LTRT-910xx.
8. In the EMS, verify that the Ethernet Switch board is enabled.
14. Hardware Replacement Procedures
Issue 1 October 2007 153