Cables - Avaya G860 Installing And Operating

4.1.3

Cables

Note 1:
Note 2:
Item
RS-232 Cables
Fiber Optic Cables
For Avaya G860 Media
Gateway Configuration
Earthing Cables
Be sure to prepare the interface connections before beginning the Avaya
G860 Media Gateway installation.
For Cable pin out information, refer to the pin out tables in 'Avaya G860
Media Gateway Boards' on page 23.
Table 24: Cabling Requirements
Requirement
For SA and ES Console Terminals (provided with the product)
The customer is responsible for providing:
PSTN STM-1/OC-3 cables (future):
Twin fiber optic cable to each STM-1/OC-3 interface using with
LC-type optical connectors for connection to dual (Tx and Rx)
155 Mbps Optical transceivers. These cables should be as
specified in GR-253-CORE. Length is determined by the
customer.
Quantity:1 fiber pair for each utilized interface on a TPM board
Small Factor Optical transceivers (SFP) modules are supplied
as part of the Media Gateway board.
(Refer to 'Connecting the PSTN and ATM Interfaces' on page
97.)
PSTN T3 cables:
Twin T3 cables to each T3 interface (Tx and Rx) using SMB
connectors.
Quantity: up to 3 cable pairs for each TPM board.
(Refer to 'Connecting the T3 PSTN Interfaces' on page 98.)
Ethernet 1000 Base-T links:
For ES/6600/RTM: One CAT 5 cable for each GbE port
connection.
Quantity: Up to 5 CAT-5 cables for each ES/6600 board.
(Refer and 'Connecting the ES/6600 IP Network CAT 5 Copper
Cabling' on page 96.)
Refer to 'Earthing Requirements' on page 17.
4. Site Preparation
Issue 1 October 2007 49