Preparing The 'Install Image; Installing The Solaris™ 9 Os On The Sc Board - Avaya G860 Installing And Operating

Media gateway
Hide thumbs Also See for G860:
Table of Contents

Advertisement

14.2.1.2

Preparing the 'Install Image'

To prepare the 'Install Image', take these 5 steps:
1.
In the Install Server's CD-ROM drive (the server used by the EMS is
recommended), insert the Solaris™ 9 OS 'Install Image' CD.
2.
Open a terminal (via Telnet or X).
3.
At the prompt, change the directory to the CD-ROM's root.
EMS-Server8:/ [root] => cd /cdrom/cdrom0
4.
If there is no directory,"cdrom0" exists, type the command, eject and try again.
EMS-Server8:/ [root] => eject
5.
At the prompt, run the 'install' script by typing ./install and press Enter.
EMS-Server8:/cdrom/cdrom0 [root] => ./install
The Install image creates a /jumpstart directory that is shared over the network.
14.2.1.3
Installing the Solaris™ 9 OS on the SC board
To install the Solaris™ 9 OS on the SC boards, take these 9 steps:
1.
On SC board, connect to the RS232 console.
2.
Identify the SC hostname, IP address and MAC address of the SC board.
Sample values are shown in red in the example below.
client224:~# ~ => ifconfig -a
lo0: flags=1000849<UP,LOOPBACK,RUNNING,MULTICAST,IPv4> mtu 8232
index 1
inet 127.0.0.1 netmask ff000000
dmfe0:
flags=1000863<UP,BROADCAST,NOTRAILERS,RUNNING,MULTICAST,IPv4> mtu
1500 index 2
inet
ether 0:3:ba:78:8e:65
3.
On the 'Install Server', open a terminal (via Telnet or X).
4.
Define the SC board.
10.7.13.94
netmask ffff0000 broadcast
14. Hardware Replacement Procedures
10.7.255.255
Issue 1 October 2007 133

Advertisement

Table of Contents
loading

Table of Contents