Post-Power Connection Test Procedures Checklist - Avaya G860 Installing And Operating

Avaya G860 Media Gateway
8.2 Post-Power Connection Test Procedures
Checklist
To complete the installation up to this point, verify the next 6 items
are correct:
1. Check the electrical connections:
•
For DC power: Verify that the power connections to the DC power inputs on the
PEMs have been made according to the desired configuration.
♦
•
For DC power: Verify the polarity of the connected cables to the DC inputs.
2. Verify that air is flowing out the air vents of the chassis by feeling the air flow at
the vents.
3. Check that there is communication via the console connected to the SA/RTM that
is associated to the initial active SC board. Perform this check on both of the SC
boards and SA/RTM pairs.
4. Using the Ethernet Switch RS-232 cable, connect to the Ethernet Switch board's
console port and verify that communication is established.
5. Verify that the external Ethernet equipment recognizes the Ethernet activity.
6. Check the LED indicators of the various boards are lit according to the table
below.
70 Installation & Operation Manual
For the TPM system configuration, two DC power inputs for full redundant
protection.