Avaya G860 Installing And Operating page 77

IP address
6. Enter the correct IP address for the Default router and press Enter.
Default router
7. Enter the correct IP address for the Subnet and press Enter. Do the same for the
Subnet mask or accept the default.
Subnet mask
8. To start the configuration, type y and press Enter.
According to IP and mask, network is 10.2.0.0.
Start configuring (y/n) ?
>>> Updated /etc/hosts ...
>>> Updated /etc/nodename ...
>>> Updated /etc/defaultrouter ...
>>> Updated /etc/hostname.dmfe0 ...
>>> Updated /etc/netmasks ...
>>> Updated hostname ...
Done
*****************************************************
9. Since this is a first-time configuration you can reboot the board at this time. To
reboot the SC board, type y and press Enter.
**
** After reboot you MUST choose option 2 (if
** not installed yet) or option 3 of this script.
**
*****************************************************
Reboot now (y/n) ?
10. Go to "Performing the Basic SC Configuration" below.
9. Configuring System Controller Software for the First Time
[10.6.8.33]: 10.2.229.253
[10.6.0.1]: 10.2.0.1
[10.6.0.0]: 10.2.0.0
[n]: y
**
**
**
**
[y]: y
Issue 1 October 2007 77