Using A Wired Network; Printing Configuration Report - Muratec MFX-3550 User Manual

Network setup
(See
SyncThru™ Web Admin Service
Web-based machine management solution for network administrators. SyncThru™ Web Admin
Service provides you with an efficient way of managing network devices and lets you remotely
monitor and troubleshoot network machines from any site with corporate internet access.
SetIP
This utility program allows you to select a network interface and manually configure the IP
addresses for use with the TCP/IP protocol. (See
setting using SetIP Program

USING A WIRED NETWORK

You must set up the network protocols on your machine to use it on your network. This chapter will
show you how this is easily accomplished.
You can use network after connecting network cable to a corresponding port on your machine.

Printing Configuration report

You can print a Network Configuration Report from the machine's control panel that will show
the current machine's network settings. This will help you to set up a network and troubleshooting
problems.
1. Press Menu on the control panel.
2. Press the up/down arrow to highlight System Setup and press OK.
3. Press the up/down arrow to highlight Reports and press OK.
4. Press the up/down arrow to highlight Network Info. and press OK.
5. Press OK when Yes highlights to confirm printing.
Network Configuration Report will then be printed out.
Using this Network Configuration Report, you can find your machine MAC address and IP
address.
For example:
MAC Address : 00:15:99:41:A2:78
IP Address : 192.0.0.192
Setting IP address
Firstly, you have to set up an IP address for network printing and managements. In most cases a
new IP address will be automatically assigned by a DHCP (Dynamic Host Configuration Protocol
Server) located on the network.
In a few situations the IP address must be set manually. This is called a static IP and is often
required in corporate Intranets for security reasons.
DHCP IP assignment: Connect your machine to the network, and wait a few minutes for the
DHCP server to assign an IP address to the machine. Then, print the Network Configuration
Report as explained above. If the report shows that the IP address has changed, the assignment
was successful. You will see the new IP address in the report.
Static IP assignment: Use SetIP program to change the IP address from your computer. If
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/... www.Manualslib.com
Using SyncThru™ Web Service.)
(Macintosh))
manuals search engine
IP setting using SetIP Program (Windows)
37
Page 2 of 24
or IP
8/4/2009