United States Of America - Muratec MFX-3550 User Manual

Regulatory information
apparatus as set out in the interference-causing equipment standard entitled "Digital Apparatus",
ICES-003 of the Industry and Science Canada.
Cet appareil numérique respecte les limites de bruits radioélectriques applicables aux appareils
numériques de Classe A prescrites dans la norme sur le matériel brouilleur: "Appareils Numériques",
ICES-003 édictée par l'Industrie et Sciences Canada.

UNITED STATES OF AMERICA

Federal Communications Commission (FCC)
Intentional emitter per FCC Part 15
Low power, Radio LAN type devices (radio frequency (RF) wireless communication devices),
operating in the 2.4 GHz/5 GHz Band, may be present (embedded) in your printer system. This
section is only applicable if these devices are present. Refer to the system label to verify the
presence of wireless devices.
Wireless devices that may be in your system are only qualified for use in the United States of
America if an FCC ID number is on the system label.
The FCC has set a general guideline of 20 cm (8 inches) separation between the device and the
body, for use of a wireless device near the body (this does not include extremities). This device
should be used more than 20 cm (8 inches) from the body when wireless devices are on. The
power output of the wireless device (or devices), which may be embedded in your printer, is well
below the RF exposure limits as set by the FCC.
This transmitter must not be collocated or operation in conjunction with any other antenna or
transmitter.
Operation of this device is subject to the following two conditions:(1) This device may not cause
harmful interference, and(2) this device must accept any interference received, including
interference that may cause undesired operation of the device.
FCC Statement for Wireless LAN use:
While installing and operating this transmitter and antenna combination the radio frequency
exposure limit of 1mW/cm2 may be exceeded at distances close to the antenna installed.
Therefore, the user must maintain a minimum distance of 20cm from the antenna at all times.
This device cannot be colocated with another transmitter and transmitting antenna.
RFID (RADIO FREQUENCY INTERFACE DEVICE)
RFID operation is subject to the following two conditions:(1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may cause undesired
operation of the device. (U.S.A., France, Taiwan only)
TAIWAN ONLY
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/... www.Manualslib.com
Wireless devices are not user serviceable. Do not modify them in any way. Modification to a
wireless device will void the authorization to use it. Contact manufacturer for service.
manuals search engine
9
Page 4 of 12
8/4/2009