Common Windows Problems; Common Linux Problems - Muratec MFX-3550 User Manual

Troubleshooting
selected in the driver.
When printing a
document in Macintosh
with Acrobat Reader 6.0
or higher, colors print
incorrectly.

Common Windows problems

"File in Use" message appears
during installation.
"General Protection Fault",
"Exception OE", "Spool 32", or
"Illegal Operation" messages
appear.
"Fail To Print", "A printer
timeout error occurred"
messages appear.
Refer to Microsoft Windows User's Guide that came with your computer for further information
on Windows error messages.

Common Linux problems

CONDITION
The machine
does not print.
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/t... www.Manualslib.com
not been configured to
recognize the optional
tray.
The resolution setting in
the printer driver may
not be matched with the
one in Acrobat Reader.
CONDITION
Exit all software applications. Remove all software from the
printer's startup group, then restart Windows. Reinstall the
printer driver.
Close all other applications, reboot Windows and try printing
again.
These messages may appear during printing. Just keep waiting
until the machine finishes printing. If the message appears in
standby mode or after printing has been completed, check the
connection and/or whether an error has occurred.
Check if the printer driver is installed in your system. Open Unified Driver
Configurator and switch to the Printers tab in Printers configuration
window to look at the list of available machines. Make sure that your machine
is displayed on the list. If not, open Add new printer wizard to set up your
device.
Check if the machine is started. Open Printers configuration and select
your machine on the printers list. Look at the description in the Selected
printer pane. If its status contains Stopped string, press the Start button.
After that normal operation of the machine should be restored. The "stopped"
status might be activated when some problems in printing occurred. For
instance, this could be an attempt to print a document when the port is
claimed by a scanning application.
Ensure the port is not busy. Since functional components of machine (printer
and scanner) share the same I/O interface (port), the situation of
simultaneous access of different "consumer" applications to the same port is
possible. To avoid possible conflicts, only one of them at a time is allowed to
gain control over the device. The other "consumer" will encounter "device
busy" response. You should open ports configuration and select the port
assigned to your machine. In the Selected port pane you can see if the port
is occupied by some other application. If this is the case, you should either
wait for completion of the current job or press the Release port button, if
you are sure that the present application is not functioning properly.
Check if your application has special print option such as "-oraw". If "-oraw" is
specified in the command line parameter, then remove it to print properly. For
Gimp front-end, select "print" -> "Setup printer" and edit command line
parameter in the command item.
The CUPS (Common Unix Printing System) version distributed with SuSE
manuals search engine
select the Device Settings tab, and set
the tray option of the Installable Options
section to Installed.
Make sure that the resolution setting in
your printer driver matches the one in
Acrobat Reader.
SUGGESTED SOLUTIONS
SUGGESTED SOLUTIONS
196
Page 25 of 27
8/4/2009