Getting Started; Setting Up The Hardware - Muratec MFX-3550 User Manual

Getting started

Getting started
This chapter gives you step-by-step instructions for setting up the USB connected machine and
software.
This chapter includes:

Setting up the hardware

Supplied software
System requirements
Installing USB connected machine's driver
Sharing your machine locally
SETTING UP THE HARDWARE
This section shows the steps to set up the hardware, as is explained in the Quick Install Guide. Make
sure you read the Quick Install Guide first and follow the steps below:
1. Select a stable location.
Select a level, stable place with adequate space for air circulation. Allow extra space to open covers
and trays.
The area should be well ventilated and away from direct sunlight or sources of heat, cold, and
humidity. Do not set the machine close to the edge of your desk or table.
Printing is suitable for altitudes under 1,500 m (4,921 ft). Refer to the altitude setting to optimize
your printing. (See
Place the machine on a flat, stable surface so that there is no incline greater than 2 mm (0.08 inch).
Otherwise, printing quality may be affected.
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/... www.Manualslib.com
Altitude adjustment.)
manuals search engine
26
Page 1 of 10
8/4/2009