Changing The Default Copy Settings; Using Special Copy Features; Id Card Copying - Muratec MFX-3550 User Manual

Copying
7. Press OK to save the selection.
8. Press Stop/Clear to return to ready mode.

CHANGING THE DEFAULT COPY SETTINGS

The copy options, including darkness, original type, copy size, collation and number of copies, can be
set to those most frequently used. When you copy a document, the default settings are used unless
they have been changed by using the corresponding buttons on the control panel.
1. Press Copy on the control panel.
2. Press Menu on the control panel.
3. Press the up/down arrow to highlight Copy Setup and press OK.
4. Press the up/down arrow to highlight Change Default and press OK.
5. Press the up/down arrow until the setup option you want highlights and press OK.
6. Press the up/down arrow until the setting you want highlights and press OK.
7. Repeat steps 5 through 6, as needed.
8. Press Stop/Clear to return to ready mode.
While you are setting copy options, pressing Stop/Clear cancels the changed settings and
restores the defaults.

USING SPECIAL COPY FEATURES

You can use the following copy features:

ID card copying

Your machine can print 2-sided originals on one sheet of A4-, Letter-, Legal-, Folio-, Executive-, B5,
A5, or A6-sized paper.
The machine prints one side of the original on the upper half of the paper and the other side on the
lower half without reducing the size of the original. This feature is helpful for copying a small-sized
item, such as a business card.
1. Press ID Copy on the control panel.
2. Place Front Side Press OK appears on the display.
3. Place the front side of an original facing down on the scanner glass where arrows indicate as
shown, and close the scanner lid.
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/... www.Manualslib.com
holding the up/down arrow allows you to quickly scroll to the number you want.
When you make a reduced copy, black lines may appear at the bottom of your copy.
This copy feature is available only when you place originals on the scanner glass.
The size of the 2-sided originals should be smaller than A5, if not, some of it won't be copied.
manuals search engine
106
Page 3 of 7
8/4/2009