Solving Other Problems; Paper Feeding Problems - Muratec MFX-3550 User Manual

Troubleshooting
installed
Tray2 has a
problem
Communication
problem
occurred with
Tray2

SOLVING OTHER PROBLEMS

The following chart lists some conditions that may occur and the recommended solutions. Follow the
suggested solutions until the problem is corrected. If the problem persists, call for service.

Paper feeding problems

Paper jams during printing.
Paper sticks together.
Multiple sheets of paper do
not feed.
Paper does not feed into
the machine.
The paper keeps jamming.
Transparencies stick
together in the paper exit.
Envelopes skew or fail to
feed correctly.
Downloaded from http://downloadcenter.samsung.com/content/UM/200907/20090721152022250/EN/english/t... www.Manualslib.com
The machine cannot communicate the
optional tray 2.
CONDITION
Clear the paper jam. (See
Check the maximum paper capacity of the tray. (See
specifications
Make sure that you are using the correct type of paper. (See
media specifications
Remove paper from the tray and flex or fan the paper.
Humid conditions may cause some paper to stick together.
Different types of paper may be stacked in the tray. Load paper of
only one type, size, and weight.
Remove any obstructions from inside the machine.
Paper has not been loaded correctly. Remove paper from the tray
and reload it correctly.
There is too much paper in the tray. Remove excess paper from
the tray.
The paper is too thick. Use only paper that meets the
specifications required by the machine. (See
specifications
If an original does not feed into the machine, the document
feeder rubber pad may require to be replaced. Contact a service
representative.
There is too much paper in the tray. Remove excess paper from
the tray. If you are printing on special materials, use the multi-
purpose tray.
An incorrect type of paper is being used. Use only paper that
meets the specifications required by the machine. (See
media specifications
There may be debris inside the machine. Open the front door and
remove any debris.
If an original does not feed into the machine, the document
feeder rubber pad may need to be replaced. Contact a service
representative.
Use only transparencies specifically designed for laser printers.
Remove each transparency as it exits from the machine.
Ensure that the paper guides are against both sides of the envelopes.
manuals search engine
and the optional tray 2. If the
problem persists, call for service.
Check the cable connecting the
machine and the optional tray 2. If
the problem persists, call for
service.
SUGGESTED SOLUTIONS
Clearing paper
.)
.)
.)
.)
187
Page 16 of 27
jams.)
Print media
Print
Print media
Print
8/4/2009