Table of Contents
Advertisement
Web OS 10.0 Application Guide
9.
Configure host routes.
Host routes are configured just like those on Web switch 1, except their costs are reversed.
Since virtual server 10.10.10.2 is preferred for Web switch 2, its host route has been given a
low cost. Because virtual server 10.10.10.1 is used as a backup in case Web switch 1 fails, its
host route has been given a high cost.
>> OSPF Interface 2 # ../host 1
>> OSPF Host Entry 1 # addr 10.10.10.1
>> OSPF Host Entry 1 # aindex 0
>> OSPF Host Entry 1 # cost 100
>> OSPF Host Entry 1 # enable
>> OSPF Host Entry 1 # ../host 2
>> OSPF Host Entry 2 # addr 10.10.10.2
>> OSPF Host Entry 2 # aindex 0
>> OSPF Host Entry 2 # cost 1
>> OSPF Host Entry 2 # enable
10.
Apply and save the configuration changes.
>> OSPF Host Entry 2 # apply
>> OSPF Host Entry 2 # save
Verifying OSPF Configuration
Use the following commands to verify the OSPF configuration on your switch:
n
/info/ospf/general
n
/info/ospf/nbr
n
/info/ospf/dbase/dbsum
n
/info/ospf/route
n
/stats/route
Refer to the Web OS 10.0 Command Reference for information on the above commands.
n
98
Chapter 4: OSPF
(Select menu for host route 1)
(Set IP address same as virtual server 1)
(Inject host route into backbone area)
(Set high cost for use as backup path)
(Enable the host route)
(Select menu for host route 2)
(Set IP address same as virtual server 2)
(Inject host route into backbone area)
(Set low cost for primary path)
(Enable the host route)
(Global command to apply all changes)
(Global command to save all changes)
212777-A, February 2002
Advertisement
Table of Contents
