Web OS 10.0 Application Guide
Configuring Bandwidth Management
The following procedure provides general instructions for configuring BWM on the switch.
Specific configuration examples begin on
1.
Configure the switch as you normally would for SLB. Configuration includes the follow-
ing tasks:
n
Assign an IP address to each of the real servers in the server pool.
n
Define an IP interface on the switch.
n
Define each real server.
n
Define a real server group.
n
Define a virtual server.
n
Define the port configuration.
For more information about SLB configuration, see
2.
Enable BWM on the switch.
N
OTE
ing /oper/swkey and entering its software key.
>> # /cfg/bwm/on
3.
Select a bandwidth policy.
Each policy must have a unique number from 1 to 64.
>> Bandwidth Management# pol 1
4.
Set the hard, soft, and reserved rate limits for the policy, in Mbps.
Typically, charges are applied for burst rates between the soft and hard limit. Each limit must
be set between 256K-1000M.
N
OTE
>> Policy 1# hard 6
>> Policy 1# soft 5
>> Policy 1# resv 4
n
454
Chapter 17: Bandwidth Management
–
If you purchased the Bandwidth Management option, make sure you enable it by typ-
–
For rates less than 1 Mbps, append a "K" suffix to the number.
page
457.
"Server Load Balancing" on page
(Turn BWM on)
(Select bandwidth policy 1)
(Set "never exceed" rate)
(Set desired bandwidth rate)
(Set committed information rate)
117.
212777-A, February 2002