Interval Configuration; Pc-Attached Wallboards - Nortel CC MIS Getting Started Manual
Nortel cc mis software: quick start
Hide thumbs
Also See for CC MIS:
- Release note (86 pages) ,
- User manual (570 pages) ,
- User manual (374 pages)
Table of Contents
Advertisement
CC MIS
CC MIS
About this Guide
Release 5.2
Interval Configuration
Intervals for each hour of the day are configured in the Maintenance Inter-
face. The intervals used by your partition can be viewed while in the Report
Parameters Definition window by selecting the Reports / Intervals com-
mand. The Interval Configuration dialog is displayed. Intervals that are al-
lowed in Release 4.0 are: 5, 10, 15, 30, and 60 minutes.
PC-Attached Wallboards
Wallboards can now be attached to the Supervisor's PC. Wallboards sup-
ported in Release 4 include: Nortel, Daktronics, and generic.
Note: Only Nortel wallboards can be connected as PC-attached wallboards.
Use the Session / Setup / Wallboards command to access the Wallboard Set-
up window.
Page xiv
CC MIS Getting Started Guide (297-2671-175)
Advertisement
Table of Contents
