Table of Contents
Advertisement
2.
Turn on URL parsing for the filter.
>> # /cfg/slb/filt 1/adv/urlp ena
3.
Enable hash to direct a cacheable URL request to a specific cache server.
By default, the host header field is used to calculate the hash key and URL hashing is disabled.
n
hash ena: Enables hashing based on the URL and the host header if it is present. Specify
the length of the URL to hash into the cache server.
n
hash disable: Disables hashing based on the URL. Instead, the host header field to calcu-
late the hash key.
If the host header field does not exist in the HTTP header, then the switch uses the source
IP address as the hash key.
Example 1: Hashing on the URL
In this example, URL hashing is enabled. If the Host field does not exist, the specified length
of the URL is used to hash into the cache server as shown in
Host field exists, the specified length of both the Host field and the URL is used to hash into
the cache server. The same URL request goes to the same cache server as shown below:
n
Client 1 request http://www.nortelnetworks.com/sales/index.htm is
directed to cache server 1.
n
Client 2 request http://www.nortelnetworks.com/sales/index.htm is
directed to cache server 1.
n
Client 3 request http://www.nortelnetworks.com/sales/index.htm is
directed to cache server 1.
212777-A, February 2002
>> # /cfg/slb/layer7/redir/hash ena
Enter new hash length [1-255]: 24
Web OS 10.0 Application Guide
Figure 15-6 on page
Chapter 15: Content Intelligent Switching
408. If the
n
407
Advertisement
Table of Contents
