Nortel Web OS Switch Software Application Manual page 89

6. Define the stub area.
>> OSPF Area (index) 1 # ../aindex 2
>> OSPF Area (index) 2 # areaid 0.0.0.2
>> OSPF Area (index) 2 # type stub
>> OSPF Area (index) 2 # enable
7. Attach the network interface to the backbone.
>> OSPF Area (index) 2 # ../if 1
>> OSPF Interface 1 # aindex 1
>> OSPF Interface 1 # enable
8. Attach the network interface to the transit area.
>> OSPF Interface 1 # ../if 2
>> OSPF Interface 2 # aindex 2
>> OSPF Interface 2 # enable
9. Configure the virtual link.
The nbr router ID configured in this step must be the same as the router ID that was config-
ured for Web switch #1 in
>> OSPF Interface 2 # ../virt 1
>> OSPF Virtual Link 1 # aindex 1
>> OSPF Virtual Link 1 # nbr 10.10.10.1
>> OSPF Virtual Link 1 # enable
10. Apply and save the configuration changes.
>> OSPF Interface 2 # apply
>> OSPF Interface 2 # save
Other Virtual Link Options
n
You can use redundant paths by configuring multiple virtual links.
n
Only the endpoints of the virtual link are configured. The virtual link path may traverse
multiple routers in an area as long as there is a routable path between the endpoints.
212777-A, February 2002
Step 2 on page 86.
Web OS 10.0 Application Guide
(Select the menu for area index 2)
(Set the area ID for OSPF area 2)
(Define area as stub type)
(Enable the area)
(Select OSPF menu for IP interface 1)
(Attach network to transit area index)
(Enable the transit area interface)
(Select OSPF menu for IP interface 2)
(Attach network to stub area index)
(Enable the stub area interface)
(Specify a virtual link number)
(Specify the transit area for the virtual link)
(Specify the router ID of the recipient)
(Enable the virtual link)
(Global command to apply all changes)
(Global command to save all changes)
Chapter 4: OSPF
n
89