Nortel Web OS Switch Software Application Manual page 241

Switch software
Table of Contents

Advertisement

WSP Content Health Checks
Wireless Session Protocol content health checks can be configured in two modes: connection-
less and connection-oriented. Connectionless WSP runs on UDP/IP protocol, port 9200.
Therefore, Alteon Web switches can be used to load balance the gateways in this mode of oper-
ation.
Web OS 10.0 provides a content-based health check mechanism where customized WSP pack-
ets can be sent to the gateways, and the switch can verify the expected response, in a manner
similar to scriptable health checks.
The content of the WSP/UDP packet that is sent to the gateway can be configured as a hexa-
decimal string, which is encapsulated in a UDP packet and shipped to the server. Hence, this
byte string should include all applicable WSP headers.
The content that the switch expects to receive from the gateway is also specified in the form of
hexadecimal byte string. The switch matches each byte of this string with the received content.
If there is a mismatch of even a single byte on the received content, the gateway fails the health
check. The user can also configure an offset for the received WSP packet: a byte index to the
WSP response content from where the byte match can be performed.
Configuring the Switch for WSP Content Health Checks
1.
Select the WAP Health Check Menu.
>> # /cfg/slb/adv/waphc
2.
Use the sndcnt command to enter the content to be sent to the WSP gateway.
>> WAP Health Check# sndcnt
Current Send content:
Enter new Send content: 01 42 15 68 74 74 70 3a 2f 77 77 77 2e 6e 6f
6b 61 6d 00
3.
Enter the content that the switch expects to receive from the WSP gateway.
>> WAP Health Check# rcvcnt
Current Receive content:
Enter new Receive content: 01 04 60 0e 03 94
N
OTE
remove spaces in between the numbers to save space on the command line. For example, type
010203040506 instead of
212777-A, February 2002
.
A maximum of 255 bytes of input are allowed on the switch command line. You may
01 02 03 04 05 06
Web OS 10.0 Application Guide
.
Chapter 10: Health Checking
n
241

Advertisement

Table of Contents
loading

This manual is also suitable for:

Web os 10.0

Table of Contents