Table of Contents
Advertisement
Web OS 10.0 Application Guide
10.
Place the real servers into a real server group.
>> Real server 3# ../group 200
>> Real server group 200# add 2
>> Real server group 200# add 3
11.
Configure ports 4 and 5, which are connected to the real servers, for server processing.
>> Real server group 200#
>> SLB port 4# ../port 5/server ena
12.
Enable server load balancing on the switch.
>> Real server group 1# /cfg/slb/on
13.
Create a filter to prevent server-to-server traffic from being redirected.
>> Layer 4# /cfg/slb/filt 10
>> Filter 10# sip any
>> Filter 10# dip 20.1.1.0
>> Filter 10# dmask 255.255.255.0
>> Filter 10# proto any
>> Filter 10# action allow
>> Filter 10# ena
14.
Create the redirection filter.
This filter will redirect outbound traffic, load balancing it among the defined real servers in the
group. In this case, the real servers represent IP interfaces on the dirty-side switch.
>> Filter 10# ../filt 15
>> Filter 15# sip any
>> Filter 15# dip any
>> Filter 15# proto any
>> Filter 15# action redir
>> Filter 15# group 1
>> Filter 15# ena
n
324
Chapter 13: Firewall Load Balancing
(Select real server group 1)
(Select real server 2 to group 200)
(Select real server 3 to group 200)
../port 4/server ena
(Select filter 10)
(From any source IP address)
(To base IP address for IF 5)
(For the range of addresses)
(For any protocol)
(Allow traffic)
(Enable the filter)
(Select filter 15)
(From any source IP address)
(To any destination IP address)
(For any protocol)
(Perform redirection)
(To real server group 1)
(Enable the filter)
212777-A, February 2002
Advertisement
Table of Contents
