Table of Contents
Advertisement
Configure Connectivity for the Secondary Dirty-Side Web Switch
Except for the IP interfaces, this configuration is identical to the primary dirty-side Web switch.
1.
Configure VLANs on the secondary dirty-side Web switch.
>> # /cfg/vlan 2
>> # add 2
>> # add 9
>> # ena
2.
Configure IP interfaces on the secondary dirty-side Web switch.
>> # /cfg/ip/if 1
>> # mask 255.255.255.0
>> # addr 195.1.1.11
>> # ena
>> # ../if 2
>> # mask 255.255.255.0
>> # addr 10.10.2.11
>> # vlan 2
>> # ena
>> # ../if 3
>> # mask 255.255.255.255
>> # addr 10.10.2.12
>> # vlan 2
>> # ena
3.
Turn STP off for the secondary dirty-side Web switch.
>> # /cfg/stp/off
4.
Configure static routes on the secondary dirty-side Web switch.
>> # /cfg/ip/frwd/route
>> # add 10.10.3.1 255.255.255.255 10.10.2.3 2
>> # add 10.10.3.2 255.255.255.255 10.10.2.4 3
>> # add 10.10.3.11 255.255.255.255 10.10.2.3 2
>> # add 10.10.3.12 255.255.255.255 10.10.2.4 3
5.
Apply and save your configuration.
>> # apply
>> # save
>> # /boot/reset
212777-A, February 2002
Web OS 10.0 Application Guide
Chapter 13: Firewall Load Balancing
n
333
Advertisement
Table of Contents
