Table of Contents
Advertisement
Preconfiguring WAP Server Load Balancing
n
Configure WAP server load balancing on Alteon AD4 and Alteon 184 platforms only.
n
Enable Virtual Matrix Architecture (VMA).
n
Disable DAM (Direct Access Mode).
n
Disable pbind and enable udp under the WAP services (ports 9200 to 9203) menu.
n
Configure for RADIUS service 1812 and 1645.
N
OTE
fied on the server.
Enabling Wireless Application Protocol SLB
1.
Enable the external notification from WAP gateway to add and delete session request.
>> # cfg/slb/adv/tpcp ena
2.
Enable TPCP for adding and deleting WAP sessions.
>> # cfg/slb/wap/tpcp ena
Configuring RADIUS Snooping
Consider the following items before configuring RADIUS snooping:
n
The same virtual server IP address must be used when load balancing both the RADIUS
accounting traffic and WAP traffic.
n
All the RADIUS servers must use the same UDP port for RADIUS accounting services.
n
Before a session entry is recorded on the switch, WAP packets for a user can go to any of
the real WAP gateways.
212777-A, February 2002
>> # /cfg/slb/adv/matrix ena
>> # /cfg/slb/adv/direct dis
>> # /cfg/slb/virt <number>/service <name|number>/pbind dis
>> # /cfg/slb/virt <number>/service <name|number>/udp ena
–
The radius service number specified on the switch must match with the service speci-
Web OS 10.0 Application Guide
Chapter 6: Server Load Balancing
n
161
Advertisement
Table of Contents
