Table of Contents
Advertisement
9.
Configure a filter to support basic WCR.
The filter must be able to intercept all TCP traffic for the HTTP destination port and must redi-
rect it to the proper port in the real server group:
>> # /cfg/slb/filt <filter number>
>> Filter <filter number># sip any
>> Filter <filter number># dip any
>> Filter <filter number># proto tcp
>> Filter <filter number># sport any
>> Filter <filter number># dport http
>> Filter <filter number># action redir
>> Filter <filter number># rport http
>> Filter <filter number># group 1
>> Filter <filter number># ena
10.
Enable URL-based WCR on the same filter.
>> # /cfg/slb/filt <filter number>/adv/urlp ena
11.
Select the appropriate NAT option.
The three NAT options are listed below. For more information about each option, see
work Address Translation Options" on page
n
No NAT option:
n
Half NAT option:
>> # /cfg/slb/filter <filter number>/adv/proxy ena
n
Full NAT option:
212777-A, February 2002
>> # /cfg/slb/filter <filter number>/adv/proxy dis
>> # /cfg/slb/port <port number>
>> SLB port <port number># pip 12.12.12.12 (Configure proxy IP address on
>> SLB port <port number># ../filt <filter number>
>> Filter <filter number># rport 3128
>> Filter <filter number># adv
>> Filter <filter number> Advanced# proxy ena(Enable proxy IP address)
Web OS 10.0 Application Guide
(Select the menu for Filter #x)
(From any source IP addresses)
(To any destination IP addresses)
(For TCP protocol traffic)
(From any source port)
(To an HTTP destination port)
(Set the action for redirection)
(Set the redirection port)
(Select real server group 1)
(Enable the filter)
397.
the physical port)
(Specify redirection port)
(Select the advance menu)
Chapter 15: Content Intelligent Switching
"Net-
n
401
Advertisement
Table of Contents
