Web OS 10.0 Application Guide
8.
Assign the filters to the switch port that connects to the Internet.
>> Filter 9# ../port 5
>> SLB Port 5# add 1-9
>> SLB Port 5# add 224
>> SLB Port 5# filt enable
Web OS allows you to add and remove a contiguous block of filters with a single command.
9.
Apply and verify the configuration.
>> SLB Port 5# apply
>> SLB Port 5# cur
Examine the resulting information. If any settings are incorrect, make appropriate changes.
10.
Save your new configuration changes.
>> SLB Port 5# save
11.
Check the server load balancing information.
>> SLB Port 5# /info/slb/dump
Check that all SLB parameters are working according to expectation. If necessary, make any
appropriate configuration changes and then check the information again.
N
OTE
is updated (every two minutes or so). To make filter changes take effect immediately, clear the
session binding table for the port (see the /oper/slb/clear command in the Web OS 10.0
Command Reference).
n
190
Chapter 7: Filtering
–
Changes to filters on a given port do not take effect until the port's session information
(Select the SLB port 5 to the Internet)
(Add filters 1-9 to port 5)
(Add the default filter to port 5)
(Enable filtering for port 5)
(Make your changes active)
(View current settings)
(Save for restore after reboot)
(View SLB information)
212777-A, February 2002