Table of Contents
Advertisement
4.
Configure static routes on the primary clean-side Web switch.
Four static routes are needed:
n
To primary dirty-side IF 2 via Firewall 1 using clean-side IF 2
n
To primary dirty-side IF 3 via Firewall 2 using clean-side IF 3
n
To secondary dirty-side IF 2 via Firewall 1 using clean-side IF 2
n
To secondary dirty-side IF 3 via Firewall 2 using clean-side IF 3
Again, the static route add command uses the following format:
add <destination address> <dest. mask> <gateway address> <source interface>
This example requires the following static route configuration:
>> # /cfg/ip/frwd/route
>> # add 10.10.2.1 255.255.255.255 10.10.3.3 2
>> # add 10.10.2.2 255.255.255.255 10.10.3.4 3
>> # add 10.10.2.11 255.255.255.255 10.10.3.3 2
>> # add 10.10.2.12 255.255.255.255 10.10.3.4 3
5.
Apply and save your changes.
>> # apply
>> # save
>> # /boot/reset
Configure Connectivity for the Secondary Clean-Side Web Switch
1.
Configure VLANs on the secondary clean-side Web switch.
>> # /cfg/vlan 3
>> # add 3
>> # add 9
>> # ena
>> # ../vlan 4
>> # add 4
>> # ena
212777-A, February 2002
Web OS 10.0 Application Guide
Chapter 13: Firewall Load Balancing
n
335
Advertisement
Table of Contents
