Table of Contents
Advertisement
Stateful Failover Configuration Example
After the VRRP setup, perform the following additional steps to enable stateful failover on the
switches.
On the Master Switch
1.
Enable stateful failover.
>> # /cfg/slb/sync/state ena
2.
Set the update interval.
>> # /cfg/slb/sync/update 10
On the Backup Switch
1.
Turn on stateful failover.
>> # /cfg/slb/sync/state ena
2.
Set the update interval.
>> # /cfg/slb/sync/update 10
N
OTE
up to two peer switches. Repeat the steps mentioned above to enable stateful failover on all the
peer switches.
212777-A, February 2002
–
The update does not have to be the same for both switches. Stateful failover supports
Web OS 10.0 Application Guide
(The default is 30)
(The default is 30)
Chapter 11: High Availability
n
285
Advertisement
Table of Contents
