Table of Contents
Advertisement
Web OS 10.0 Application Guide
3.
Configure VRRP on the primary dirty-side Web switch.
VRRP in this example requires two virtual routers–one for the subnet attached to the routers,
and one for the subnet attached to the firewalls.
>> # /cfg/vrrp
>> # on
>> # vr 1
>> # vrid 1
>> # addr 195.1.1.9
>> # if 1
>> # prio 101
>> # share dis
>> # ena
>> # track
>> # ifs ena
>> # ports ena
>> # /cfg/vrrp/vr 2
>> # vrid 2
>> # addr 10.10.2.9
>> # if 2
>> # prio 101
>> # share dis
>> # ena
>> # track
>> # ifs ena
>> # ports ena
4.
Configure the VRRP peer on the primary dirty-side Web switch.
>> # /cfg/slb/sync
>> # prios d
>> # peer 1
>> # ena
>> # addr 195.1.1.11
5.
Apply and save your configuration changes.
>> # apply
>> # save
6.
Synchronize primary and secondary dirty-side Web switches.
>> # /oper/slb/sync
n
340
Chapter 13: Firewall Load Balancing
(Configure virtual router 1)
(For the subnet attached to the routers)
(Configure virtual router 2)
(For the subnet attached to the firewall)
212777-A, February 2002
Advertisement
Table of Contents
