The ports are configured as follows:
>> Virtual server 1# /cfg/slb/port 1
>> SLB port 1# server ena
>> SLB port 1# ../port 2
>> SLB port 2# server ena
>> SLB port 2# ../port 3
>> SLB port 3# server ena
>> SLB port 3# ../port 5
>> SLB port 5# client ena
>> SLB port 5# ../port 6
>> SLB port 6# client ena
7.
Enable, apply, and verify the configuration.
>> SLB port 6# ..
>> Layer 4# on
>> Layer 4# apply
>> Layer 4# cur
Examine the resulting information. If any settings are incorrect, make the appropriate changes.
8.
Save your new configuration changes.
>> Layer 4# save
N
OTE
changes if you wish them to remain in effect after switch reboot.
9.
Check the SLB information.
>> Layer 4# /info/slb/dump
Check that all SLB parameters are working according to expectation. If necessary, make any
appropriate configuration changes and then check the information again.
212777-A, February 2002
–
You must apply any changes in order for them to take effect, and you must save
Web OS 10.0 Application Guide
(Select physical switch port 1)
(Enable server processing on port 1)
(Select physical switch port 2)
(Enable server processing on port 2)
(Select physical switch port 3)
(Enable server processing on port 3)
(Select physical switch port 5)
(Enable client processing on port 5)
(Select physical switch port 6)
(Enable client processing on port 6)
(Select the SLB Menu)
(Turn Server Load Balancing on)
(Make your changes active)
(View current settings)
(Save for restore after reboot)
(View SLB information)
Chapter 6: Server Load Balancing
n
127