Modulation Board (Aux1) - Carrier 50PD05 Operating And Service Instructions

Modulation Board (AUX1)
The AUXI board controls the compressor capacity and the indoor
fan speed (See Fig. 18 and Table 21.) It outputs a l-5vdc and a
2-10vdc signal to the DSC and VFD for capacity and fan speed,
respectively. This board is also used as the LEN connection buss
for the ECB, therefore must be operational for the ECB to
communicate.
IMPORTANT: The AUXI board has an 8-position DIP switch
(SI) that is factory set for its LEN address. All the switches must
be in the off position except 4, 5 and 7 which are on (off is towards
the center of the board). Do not change this setting.
DIP SWITCH
TR1 TR2 TR3 TR4 TR5 TR(_ TR7 TR8
Fig. 18 - Modulation Board (AUX1)
(:08658
Table 21 -- AUX1 Connections
DISPLAY CONNECTION
NAME POINT DESCRIPTION TYPE OF I/O PIN NUMBER
OUTPUTS
Input power from TRAN1 24 VAC J1, 11-12
CAPC Compressor Capacity 1-5vdc CH9
RSPD Commanded Fan Speed 2-10vdc CH10
COMMUNICATION
Local Equipment Network (LEN) communication J9, 1-3
Local Equipment Network (LEN) communication J9, 1-3
51