Replacing The Alarm Relay Wires From The Mx2020 Craft Interface; Disconnecting The Alarm Relay Wires From The Mx2020 Craft Interface; Figure 178: Installing A Cb-Re - Juniper MX2020 Hardware Manual

MX2020 3D Universal Edge Router Hardware Guide
Related
Documentation

Replacing the Alarm Relay Wires from the MX2020 Craft Interface

Disconnecting the Alarm Relay Wires from the MX2020 Craft Interface

422

Figure 178: Installing a CB-RE

0
MX2020 CB-RE Description on page 59
MX2020 CB-RE LEDs on page 62
Preventing Electrostatic Discharge Damage to an MX2020 Router on page 558
Disconnecting the Alarm Relay Wires from the MX2020 Craft Interface on page 422
1.
2. Connecting the Alarm Relay Wires to the MX2020 Craft Interface on page 423
To disconnect the alarm relay wires from the router and an alarm-reporting device (see
Figure 141 on page 283):
Disconnect the existing wire at the external device.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
19
Copyright © 2015, Juniper Networks, Inc.