Displaying Installed Licenses And License Usage Details - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Purpose
Action
Meaning
Copyright © 2010, Juniper Networks, Inc.
To monitor your installed licenses, perform the following tasks:
Displaying Installed Licenses and License Usage Details on page 103
Displaying Installed License Keys on page 104

Displaying Installed Licenses and License Usage Details

Verify that the expected license is installed and active on the switch and fully covers the
switch configuration.
From the CLI, enter the
show system license
list, enter the
show system license usage
output, enter
show system license installed
user@switch> show system license
License usage:
Feature name
bgp
isis
ospf3
ripng
mpls
Licenses installed:
License identifier: JUNOS204558
License version: 2
Valid for device: BN0208380000
Features:
ex—series - Licensed routing protocols in ex-series
permanent
The output shows the license or licenses (for Virtual Chassis deployments) installed on
the switch and license usage. Verify the following information:
If a feature that requires a license is configured (used), a license is installed on the
switch. The
Licenses needed
The appropriate number of licenses is installed. Each switch requires one license. For
a Virtual Chassis deployment, two licenses are recommended for redundancy.
The expected license is installed.
Chapter 7: Verifying Software Installation
command. (To display only the
command. To display only the
.)
Licenses Licenses
used installed
1
0
0
0
0
column must show that no licenses are required.
License usage
Licenses installed
Licenses Expiry
needed
1 0 permanent
1 0 permanent
1 0 permanent
1 0 permanent
1 0 permanent
103