Ex8200 Switch Default Configuration - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation

EX8200 Switch Default Configuration

Copyright © 2010, Juniper Networks, Inc.
protocols {
igmp-snooping {
vlan all;
}
rstp;
lldp {
interface all;
}
lldp-med {
interface all;
}
}
ethernet-switching-options {
storm-control {
interface all;
}
}
Reverting to the Default Factory Configuration for the EX Series Switch on page 415
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 199
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 201
Understanding Configuration Files for EX Series Switches on page 381
EX Series Switches Interfaces Overview on page 1239
Each EX8200 switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as the ARP aging timer, the
system log, and file messages, while also enabling the LLDP protocol, the RSTP protocol,
IGMP snooping, and storm control.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See "Reverting to the Default Factory Configuration for the EX Series
Switch" on page 415.
This topic shows the factory default configuration file of an EX8200 switch:
system {
arp {
aging-timer 5
}
}
syslog {
user * {
any emergency;
}
file messages {
any notice;
authorization info;
}
Chapter 18: Configuration File Management Overview
403