Table 64: Show System Uptime Output Fields - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Additional Information
Required Privilege
Level
List of Sample Output
Output Fields

Table 64: show system uptime Output Fields

Field Name Field Description
Current system time in UTC.
Current time
Date and time when the Routing Engine on the router or switch was last booted and how long it has
System booted
been running.
Date and time when the routing protocols were last started and how long they have been running.
Protocols started
Date and time when a configuration was last committed. Also shows name of user who issued the
Last configured
last
time and up Current time, in the local time zone, and how long the router or switch has been operational.
users Number of users logged in to the router or router.
load averages Load averages for the last 1 minute, 5 minutes, and 15 minutes.
show system uptime show system uptime
Copyright © 2010, Juniper Networks, Inc.
—(TX Matrix routers only) (Optional) Show time since the system rebooted and
scc
processes started for the TX Matrix router (or switch-card chassis).
sfc number —(TX Matrix Plus routers only) (Optional) Show time since the system rebooted
and processes started for the TX Matrix Plus router (or switch-fabric chassis). Replace
number with .
0
By default, when you issue the
Plus master Routing Engine, the command is broadcast to all the T640 (in a routing
matrix based on a TX Matrix router) or T1600 (in a routing matrix based on a TX Matrix
Plus router) master Routing Engines connected to it. Likewise, if you issue the same
command on the TX Matrix or TX Matrix Plus backup Routing Engine, the command is
broadcast to all the T640 (in a routing matrix based on a TX Matrix router) or T1600 (in
a routing matrix based on a TX Matrix Plus router) backup Routing Engines that are
connected to it.
view
show system uptime on page 331
show system uptime all-lcc (TX Matrix Router) on page 332
show system uptime all-lcc (TX Matrix Plus Router) on page 332
Table 64 on page 331 describes the output fields for the
Output fields are listed in the approximate order in which they appear.
commit command.
user@host> show system uptime
Current time: 1998-10-13 19:45:47 UTC
System booted: 1998-10-12 20:51:41 UTC (22:54:06 ago)
Protocols started: 1998-10-13 19:33:45 UTC (00:12:02 ago)
Chapter 17: Operational Commands for System Setup
show system uptime command on a TX Matrix or TX Matrix
show system uptime command.
331