Request Chassis Pic - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

request chassis pic

Syntax
Syntax (TX Matrix and
TX Matrix Plus Router)
Release Information
Description
Options
Copyright © 2010, Juniper Networks, Inc.
request chassis pic (offline | online) fpc-slot slot-number pic-slot slot-number
request chassis pic (offline | online) fpc-slot slot-number pic-slot slot-number
<lcc number>
Command introduced before Junos OS Release 7.4.
Command introduced in Junos OS Release 9.0 for EX Series switches.
Control the operation of the PIC.
NOTE: The request chassis pic (offline | online) fpc-slot slot number pic-slot
command is not supported for built-in PICs on MX Series routers.
slot-number
To view a list of built-in PICs on the router or switch chassis, use the
chassis hardware
NOTE: T1600 routers and TX Matrix Plus routers with 100-Gigabit Ethernet
PICs require two adjacent PIC slots, 0 and 1, for each PIC. Therefore, only
and
online offline
and
online offline
and PIC combination is not allowed.
—Take the PIC offline.
offline
online —Bring the PIC online.
—Flexible PIC Concentrator (FPC) slot number. Replace
fpc-slot slot-number
with a value appropriate for your router or switch:
EX Series switches:
EX3200 switches and EX4200 standalone switches—0.
EX4200 switches in a Virtual Chassis configuration—0 through 9 (switch's
member ID).
EX8208 switches—0 through 7 (line card).
EX8216 switches—0 through 15 (line card).
M5, M7i, M10, and M10i routers—0 or 1.
M20 routers—0 through 3.
M120 routers—0 through 5.
MX960 routers—0 through 11.
Chapter 17: Operational Commands for System Setup
command.
command options to PIC slot 0 are allowed. Use of the
command options for PIC slot 1 with the described router
show
slot-number
253