Ex3200 Default Configuration - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation

EX3200 Default Configuration

Copyright © 2010, Juniper Networks, Inc.
family ethernet-switching;
}
}
ge-0/1/2 {
unit 0 {
family ethernet-switching;
}
}
ge-0/1/3 {
unit 0 {
family ethernet-switching;
}
}
}
system {
commit {
factory-settings {
reset-chassis-lcd-menu;
reset-virtual-chassis-configuration;
}
}
Configuration Files Terms on page 382
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 199
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 201
Understanding Configuration Files for EX Series Switches on page 381
EX2200 Switches Hardware Overview on page 29
Each EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as
Power over Ethernet (PoE), storm control, and Ethernet switching on all interfaces; and
enables the LLDP and RSTP protocols.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See "Reverting to the Default Factory Configuration for the EX Series
Switch" on page 415.
The following factory default configuration file is for an EX3200 switch with 24 ports (for
models that have more ports, this default configuration file has more interfaces):
NOTE: In this example,
ports. Optional uplink modules provide either two 10-gigabit small form-factor
pluggable (XFP) transceivers (
transceivers (
ge-0/1/0
uplink module, the interfaces for both are shown below.
Chapter 18: Configuration File Management Overview
syslog
ge-0/0/0 through ge-0/0/23
and
xe-0/1/0 xe-0/1/1
through ). Although you can install only one
ge-0/1/3
and ; configures
commit
are the network interface
) or four 1-gigabit SFP
389