Ex4200 Default Configuration - Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual

Related
Documentation

EX4200 Default Configuration

Copyright © 2010, Juniper Networks, Inc.
family ethernet-switching;
}
}
}
protocols {
igmp-snooping{
vlan all;
}
lldp {
interface all;
}
lldp-med {
interface all;
}
rstp;
}
ethernet-switching-options {
storm-control {
interface all;
}
}
poe {
interface all;
}
Reverting to the Default Factory Configuration for the EX Series Switch on page 415
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 199
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 201
Understanding Configuration Files for EX Series Switches on page 381
EX Series Switches Interfaces Overview on page 1239
Each EX Series switch is programmed with a factory default configuration that contains
the values set for each configuration parameter when a switch is shipped. The default
configuration file sets values for system parameters such as
Power over Ethernet (PoE), storm control, and Ethernet switching on all interfaces; and
enables the LLDP and RSTP protocols.
When you commit changes to the configuration, a new configuration file is created that
becomes the active configuration. You can always revert to the factory default
configuration. See "Reverting to the Default Factory Configuration for the EX Series
Switch" on page 415.
The following factory default configuration file is for an EX4200 switch with 24 ports
(for models that have more ports, this default configuration file has more interfaces):
Chapter 18: Configuration File Management Overview
syslog and commit ; configures
393