Juniper JUNOS OS 10.4 - FOR EX REV 1 Manual page 304

Complete Software Guide for Junos
200
®
OS for EX Series Ethernet Switches, Release 10.4
Stop Bits—1
DCD State—Disregard
To connect and configure the switch from the console:
Connect the console port to a laptop or PC using the RJ-45 to DB-9 serial port adapter.
1.
The RJ-45 cable and RJ-45 to DB-9 serial port adapter are supplied with the switch.
EX2200, EX3200, or EX4200 switch—The console port is located on the rear panel
of the switch.
EX4500 switch—The console port is located on the front panel of the switch.
EX8200 switch—The console port is located on the Switch Fabric and Routing
Engine (SRE) module in slot SRE0 in an EX8208 switch or on the Routing Engine
(RE) module in slot RE0 in an EX8216 switch.
At the Junos OS shell prompt
2.
Enter the hostname. This is optional.
3.
Enter the root password you plan to use for this device. You are prompted to re-enter
4.
the root password.
Enter to enable services like Telnet and SSH. By default, Telnet is not enabled and
5. yes
SSH is enabled.
NOTE: When Telnet is enabled, you will not be able to log in to an EX
Series switch through Telnet using
only for SSH access.
Use the Management Options page to select the management scenario:
6.
NOTE: On EX4500 and EX8200 switches, only the out-of-band
management option is available.
Configure in-band management
Use the default VLAN.
Create a new VLAN—If you select this option, you are prompted to specify the
VLAN name, VLAN ID, management IP address, and default gateway. Select the
ports that must be part of this VLAN.
Configure out-of-band management
management interface. Use this IP address to connect to the switch.
, type .
root% ezsetup
root credentials. Root login is allowed
. In this scenario you have the following two options:
. Specify the IP address and gateway of the
Copyright © 2010, Juniper Networks, Inc.