Use The Device View; Configure Power Over Ethernet; Configure The Global Poe Settings - NETGEAR GS418TPP User Manual

8-Port or 16-Port Gigabit Smart Managed Pro Switch Model GS418TPP, GS510TLP, and GS510TPP
8. In the Max Samples to keep field, enter the maximum number of samples to keep.
This is a global setting and is applied to all interfaces. The range is 1 to 168.The default
value is 168.
9. Click the Apply button.
Your settings are saved.
The Percentage LPI time field shows the time spent in LPI mode the since EEE counters
were last cleared.
The following table describes the nonconfigurable fields.
Table 23. Interface Green Mode EEE LPI History information
Field
Sample No.
Time Since The Sample Was
Recorded
Percentage Time spent in LPI
mode since last sample
Percentage Time spent in LPI
mode since last reset

Use the Device View

For information about the device view, see Change the language of the local browser
interface on page 24.

Configure Power over Ethernet

You can configure the global Power over Ethernet (PoE) configuration settings and the PoE
settings for each port.

Configure the global PoE settings

To configure the PoE settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
Configure System Information
Description
Sample index.
Each time the page is refreshed, it shows a different time as it reflects the
difference between current time and time at which the sample was
recorded.
Percentage of time spent in LPI mode during the current measurement
interval.
Percentage of time spent in LPI mode since EEE LPI statistics were reset.
80 User Manual