The Firewall's Rear Panel - NETGEAR FVM318 Reference Manual

Reference Manual for the Model FVM318 Cable/DSL ProSafe Wireless VPN Security Firewall
These LEDs are green when lit, except for the TEST LED, which is amber.
Table 1-1: LED Descriptions
Label
POWER
TEST
MODEM
INTERNET
100
LINK/ACT (Activity) On/Blinking
LOCAL
100
LINK/ACT
(Link/Activity)

The Firewall's Rear Panel

The rear panel of the FVM318
Viewed from left to right, the rear panel contains the following elements:
• DB-9 serial port for modem connection
• Factory Default Reset push button
• Eight Local Ethernet RJ-45 ports for connecting the firewall to the local computers
• Internet WAN Ethernet RJ-45 port for connecting the firewall to a cable or DSL modem
• AC power adapter input
1-6
Activity Description
On Power is supplied to the firewall.
On The system is initializing.
Off The system is ready and running.
On/Blinking The port detected a link with the Internet WAN connection or
Remote Access Server. Blinking indicates data transmission.
On/Blinking The Internet port is operating at 100 Mbps.
The port detected a link with the Internet WAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
On/Blinking The Local port is operating at 100 Mbps.
On/Blinking The Local port has detected a link with a LAN connection and is
operating at 10 Mbps. Blinking indicates data transmission.
(Figure 1-2) contains the connections identified below.
M O DEM 8
Figure 1-2: FVM318 Rear Panel
LO CA L
1 0 / 1 0 0 M
IN TER N ET
7 6 5 4 3 2 1
1 2 V D C O . 5 A
Introduction