Configuring Netbeui For Printing - Ricoh AP2600N User Manual

Windows NT 4.0 Configuration
C
Click the [Services] tab, and confirm that "Microsoft TCP/IP Printing" is in-
stalled.
If "Microsoft TCP/IP Printing" is not installed, click [Add] on the [Services ]
tab, and install it. For more information about installing and configuring net-
work services, see Windows NT Help.

Configuring NetBEUI for Printing

Follow these instructions to configure the Network Interface Board and Win-
dows NT to use the NetBEUI protocol.
3
Configuring the printer
Configure the printer to use the NetBEUI protocol.
• Confirm that the NetBEUI protocol is set to be active. (The factory default is
active.)
Reference
For more information about how to make the above settings, see the "Setup
Guide" that comes with the printer.
Configuring a Windows NT computer
Install the NetBEUI protocol on the Windows NT computer, and change the
LAN adapter number (Lana Number).
A
Open [Control Panel] and double-click the [Network] icon. Confirm that "Net-
BEUI Protocol" is listed in the [Network Protocols] box on the [Protocols] tab.
Note
❒ If the NetBEUI protocol is not installed, click [Add] on the [Protocols] tab,
and install it. For more information about installing the NetBEUI protocol,
see Windows NT Help.
B
Change the Lana Number. Click the [Services] tab, click "NetBIOS Inter-
face" in the [Network Services] box , and click [Properties].
C
Click the Lana Number corresponding the Nbf protocol of the [Network
Route] headline, and click [Edit].
D
Type "0" as the Lana Number.
Note
❒ If the other protocol's Lana Number is configured with "0", you must
change the Lana Number a number other than "0".
E
Click [OK].
34