Ricoh AP2600N User Manual page 40

Installing Options
C
If the Duplex Unit is installed,
push down the lever on right side
(A A A A ) and pull it out until the Du-
plex Unit stops (B B B B ).
Zcex320j.eps
2
D
Use a coin to remove the two
screws.
Note
These screws are used again in
step M.
Zcex281j.eps
E
Pull out the handle of the control-
ler board.
Zcex371j.eps
28
F
Pull the handle and slide the con-
troller board out.
Zcex261j.eps
G
Place the controller board on a flat
surface.
H
Use a coin to remove the two
screws, and then remove the cov-
er.
Note
These screws are used again in
step J.
The removed cover is not re-
quired to install the Network In-
terface Board.
Zcex410j.eps