Installing Envelope Feeder Type 2600 - Ricoh AP2600N User Manual

Installing Options
ZDDH052N.eps
2
E
Attach the interface cable to the
printer.
F
Plug the printer's power cord
back into the wall outlet and turn
on the power switch.
Note
After installing the last option that
you want, print a configuration
page to confirm the installation. If
the new device is listed in the col-
umn of configuration options, then
it has been properly installed. For
more information about printing a
configuration page, see "Printing a
Configuration Page" in the Printer
Reference provided as a PDF file
on the CD-ROM labeled "Operat-
ing Instructions".
Reference
For information about loading pa-
per, see "Loading Paper in the Op-
tional Paper Tray" in the Printer
Reference provided as a PDF file
on the CD-ROM labeled "Operat-
ing Instructions".
16
Installing Envelope Feeder
Type 2600
Note
This unit is a tray that slides into
the optional Paper Feed Unit.
Without the optional Paper Feed
Unit, this Envelope Feeder cannot
be used.
Your printer can have two optional
Paper Feed Units. However, the
Envelope Feeder must be used in
the top-most optional Paper Feed
Unit (tray 2). It cannot be used in
the bottom-most optional Paper
Feed Unit (tray 3).
Important
Do not slide more than one paper
tray out at the same time. Having
more than one paper tray filled
with paper in a fully extended po-
sition could cause the machine to
fall down.
A
Check the contents of the box for
the following items:
• Envelope Feeder
• Installation Guide
B
Pull out the second paper tray
(tray 2) of the optional Paper Feed
Unit until it stops. After that, lift
it slightly, and then pull it out.
Zddp330e.eps