Ricoh AP2600N User Manual page 174

Troubleshooting
Paper misfeeds occur frequent-
ly.
The operation panel error mes-
sage stays on after removing the
misfed paper.
Output are not delivered to the
selected tray you require.
5
The printed image is different
from the image on the compu-
ter.
It takes too much time to resume
printing.
The image is printed in the
wrong orientation.
Part of the image cannot be
printed.
Network configurations you have
made do not become effective.
Note
❒ If the problem cannot be solved, contact your sales or service representative.
80
Status
Check the paper size settings. The size set with the paper size
dial might be different from the actual paper size. Make the
correct dial setting.
See P.38 "Loading Paper and Other Media".
Use the recommended paper. Avoid using curled, folded,
wrinkled, perforated or glossy paper. See P.36 "Paper not sup-
ported by this printer".
Clean the paper feed roller, friction pad and/or registration roll-
er, if they are dirty. See P.92 "Cleaning the Paper Feed Roller".
Open the front cover of the printer and then close it. See P.81
"Removing Misfed Paper".
Check the paper size settings. The size selected with the pa-
per size dial might be different from the actual paper size.
Make the correct dial setting.
See P.38 "Loading Paper and Other Media".
When using the bypass tray, set the paper size using the op-
eration panel.
See P.38 "Loading Paper and Other Media".
When you are using a Windows operating system, the print-
er driver settings override those set using the operation pan-
el. Set the desired output tray using the printer driver. See
the driver's online Help file.
When you use some functions, such as enlargement and re-
duction, the layout of the image might be different from that
shown in the computer display.
The data is so large or complex that it takes time to process
it. If the Data In indicator is blinking, the data processing is
being done. Just wait until it resumes.
Changing the paper feed direction may sometimes reduce
the time to resume printing.
Set the correct orientation under the "PCL Menu" with the
operation panel. See P.124 "PCL Menu".
Confirm that the setting of orientation has been set in the ap-
plication you use.
Set the correct paper size and feed direction that matches
tray settings on the RPCS printer driver.
A paper size which is smaller than that selected in the appli-
cation is used for printing. Load the correct size of paper.
Print a configuration page and check the network settings.
Possible Causes, Descriptions, and Solutions